Why are half of my Christmas lights out?

by | Nov 20, 2019

We hear this question from folks who are puzzled that their lights worked fine last season but are half out when they pull them out of storage.

Or their lights suddenly half go out during installation. 

What gives?

Incandescent Christmas tree lights (aka mini lights) are wired in series so if your lights go partially out you have one of three issues:

1. A light bulb has come out of its socket or is half out of its socket and it has brought down the circuit. For light strings that commonly have over 50 bulbs, they are constructed in 2 or more continuous circuits. If a bulb is missing in a circuit only the bulbs in series of it will go out. That’s how you can lose 1/2 or 1/3 or 1/4 of the string.

But don’t lights stay on if a bulb burns out?

Yes, as a general rule of thumb, a small wire at the base of each glass bulb will continue to conduct electricity if the filament “burns out” but if the bulb is actually out of its socket, the lights don’t actually stay on. 

The solution:  Visually inspect each bulb in the part of the Christmas light string that is out. Don’t take out and reinsert each bulb because that’s hard on fingers and will more than likely create larger problems. Check for any bulb that is missing or partially unseated from the socket and if you find a space or wonky bulb, replace the bulb with one of the two extra bulbs that hopefully were included with your light set or gently push the bulb back into its socket.

2. The rating of the light string was exceeded and the bulbs blew out the wire at the base of each bulb that is supposed to conduct electricity. This happens sometimes when the bulbs are “smoked”. 

The solution:  Check the rating of the light string and don’t plug in more lights than the manufacturer specifies. Visually check the part of the light string that is out and replace any smoked bulbs. 

Note, if you’ve run way too many lights in series you may have permanently damaged your light sets. Purchasing new sets may be necessary if replacing bulbs don’t work for you.

3.  There is an issue with the wiring harness and the copper wire is broken in the string.  If all the bulbs are seated and none are smoked, more than likely there is an issue with the actually wiring of the Christmas light string. 

Damage to the wiring can be caused by age, squirrels, pulling and tugging on the light strings during take-down at the end of Season.

If this is the problem with your light string, the best solution is to begin again with a new string of lights. 

What if the entire string of lights goes out?

If the entire string of lights is out, the issue could be that it is on a single circuit and is due to one of the issues above or the fuse for the entire string might be out.

See our blog about the entire string doing down for more information and troubleshooting tips. 

Why are half of my Christmas lights out?
PIN & SAVE for later!

People who read this blog post also read this:

Recent Posts

Get this Look: Traditional Glass C9 Bulbs

Get this Look: Traditional Glass C9 Bulbs

This project used 625 LED bulbs installed into SPT-2 cord purchased in a bulk spool. To create this look, start with this supply list. Materials C9 Spool 1000-feet 9 inch spacing green wire SPT-2 C9 White Glass Light Bulbs C9 Rubber O-Ring Green Male Gilbert Plugs...

read more

2 Comments

  1. Bob LF

    On one of my 150 mini bulb strands there are three with bases that are white instead of green, and the bulbs in them look a little different. I can remove them from the socket, but I can’t seem to get the bulb out of the base. What are these bulbs for, and should they be replaceable? Thanks.

    Reply
    • Shellie Gardner

      Sorry we missed your comment, Bob, and it took us so long to reply. That is a puzzler. We’ve not seen a string of lights that has bases that are actually different than the rest of the string with different kinds of bulbs.

      That sounds like some sort of custom light string. We have seen strings pre-installed on Christmas trees will sometimes have unexpected innovations like this. Since your bulbs can be removed, historically, that can indicate there are replacements available. Reach out to the manufacturer or for replacements or cannibalize a replacement bulb from one of your existing sets. Sometimes one set has to sacrifice for all the others. Hopes that helps a little.

      Reply

Submit a Comment

Your email address will not be published. Required fields are marked *

Related Blog Posts

Are C7 and C9 bulbs the same?

Are C7 and C9 bulbs the same?

Are C7 and C9 bulbs the same?Short Answer: No, they are very similar but are different sizes. Continue reading the long answer for photos and more information. Longer Answer: C7 bulbs are shorter with smaller diameters than C9s. Both are installed in 18 AWG...

read more
Christmas Lights Lingo!

Christmas Lights Lingo!

Common Christmas Lights Terminology and Vocabulary 5mm This is a shape of LED lens that is about the shape of and slightly smaller than a pencil eraser. It has been referred to as "wide angle" and "conical" in the past since there is a cone shape molded into the lens...

read more
Mini Light Spacing Discussed

Mini Light Spacing Discussed

There are 3 standard spacings for mini lights. Choosing the best spacing is essential for a polished project and can be tricky. We hope a quick visual will help you decide. Here are those three spacings: Standard Christmas Light Spacing A word about lengths of...

read more
Get This Look: Our Christmas Angel

Get This Look: Our Christmas Angel

Ed from Crawford, TX sent us this photo of his beautiful angel project. Here is what he had to say: Earlier this year I contacted you for help in securing lights and clips for our Christmas Angel. We had the angel for years but weather and time took their toll on not...

read more
LED Bulbs: Comparing the Whites! 2022 Edition

LED Bulbs: Comparing the Whites! 2022 Edition

This year, we are releasing Natural Pure White, the third available color white in our LED product line. Commercial C9 LED bulbs with E17 bases and 5mm light strings have been released for the 2022 season. More versions will follow next year. Here is a photo comparing...

read more
Get this Look: A Multiple Color Christmas!!

Get this Look: A Multiple Color Christmas!!

Thank you, Stephen, for sending us photos of your Christmas lights display. We enjoyed seeing the fun color combinations created using different styles of plug-and-play LED Christmas light strings. Projects like this are based on the types of products listed below....

read more